Eicon Networks CX1 Manual de Instalação descarregar pdf (Página 84)

G&R

-TS points to a TS (Transport Station) directive somewhere else in the file. If

you omit the option the default TS is used.

rsc is2b

rsc en3e -addr 54:62

rsc is2b -ii 15 -ts fep1_wan

To set up backup routes you just specify multiple -ts routes:

rsc -ts route1 route2 route3

These are then tried in order until a connection succeeds or the end of the list is

reached.

Alternatively to configure load balancing you use:

rsc -ts route1 route2 route3 -lb 60 20 20

In this example route1 gets 60% of the load, route2 20% and route3

20%. If the first priority route has a connect failure the second priority is tried

etc. until a connection succeeds or the last priority is reached. A total of 8

routes can be specified.

The software remembers when a transport disconnection or time-out happens

while trying to connect, and the node is suspended to avoid repeated connection

attempts using a route that is down. The suspension time may be configured

with the -si parameter to the ts directive.

If all routes to a given remote session control ID are marked as down then a

connection is tried using the first priority route. If the connection succeeds that

route is marked as being up again.

TS - Transport Station

TS name -CLASS x -NS xxxx [-TPDU x] [-X25CALL xxxx]

[-X25FAC xxxx] [-EXP] [-NOEXP] [-SI nn] [-DFLT] [-TP tprovider]

Describes how to open a transport connection to reach remote session control

entities (DSA nodes). You need one for each remote transport station to which

you will be connecting. A transport station is the transport service access point,

which can reside in a FEP (Front End Processor) or in the mainframes that have

a direct connect capability, such as GCOS6, GCOS7 with ISL, GCOS7 or

GCOS8 with FCP cards (FDDI adapters), GCOS8 GNSP or GCOS7 Diane.

Gline Line Handlers and Configuration

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 132 133

Sem comentários

Eicon Networks CX1 Manual de Instalação Página 84