
Across the Boards
Communications Device Drivers
Section 6 - MAINCON Driver Configuration
Page 311
cfSOFTWARE Confidential,
2000
6.24 MAINCON Panel E4
Telnet VT320
Configuration filename: MAINCFG.TN4
Used by cf Device Drivers:
#
Name Description
103 CFXT4LW Telnet VT320 LAN Workplace
104 CFXT4NF Telnet VT320 PC/NFS
105 CFXT4NW Telnet VT320 Newt/Chameleon
106 CFXT4WS Telnet VT320 Windows Sockets
107 CFXT4FT Telnet VT320 FTP PC/TCP
109 CFXT4IO Telnet VT320 IBM TCP/IP/OS2
110 CFXT4FO Telnet VT320 FTP/PC/TCP/OS2
111 CFXT4LO Telnet VT320 Novell LWP/OS2
__________________
ACROSS-THE-BOARDS(r) Config
__________________
Page 1 of 14
--- Protocol Converter (TELNET VT320) ---
Autowrap (0 or 1)....................... 0
Reset needed after BELL? (0=No, 1=Yes).. 0
Flicker check time (in 100ths second)... 0
Half duplex (0 OR 1).................... 0
Trace size in K bytes................... 0
Destination Port Number................. 23
ASCII or Binary (0 or 1)................ 0
0: Data does not wrap to next line when the margin is reached. 1: Data wraps to
the next line when margin is reached.
F10: write config to disk Esc: Exit PgDn: next config menu
1. Autowrap
When set to ‘1’, this switch causes the cursor to wrap to the beginning of the next line automatically when
the last position in a line is written to by the protocol converter.
2. BEL Reset
If the protocol converter locks the keyboard after sending a BELL character, setting this switch to ‘1’ will
cause a RESET key sequence to be sent after receiving a BELL. The RESET key is defined in the 3101
KEY TABLE.
3. Flicker
Controls how much extra time (in 100ths of a second) will be spent waiting to insure that the protocol
converter has stopped sending data.
Comentários a estes Manuais