Eicon Networks DIVA T/A ISDN Modem Guia do Utilizador Página 88

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 191
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 87
Chapter Seven: Setting up the Phone Ports Supplementary services
88
To enable DIVA LAN ISDN Modem Call Waiting
1.
Lift the receiver, then wait for a dial tone.
2.
Press *43#.
3.
Three rising tones are played to confirm that Call Waiting has been enabled.
To disable DIVA LAN ISDN Modem Call Waiting
1.
Lift the receiver, then wait for a dial tone.
2.
Press #43#.
3.
Three falling tones are played to confirm that Call Waiting has been disabled.
To determine if DIVA LAN ISDN Modem Call Waiting is enabled
1.
Lift the receiver, then wait for a dial tone.
2.
Press *#43#.
3.
If enabled, you will hear three rising tones; if disabled, you will hear three falling tones.
ISDN Call Waiting
ISDN Call Waiting is handled by your provider and does not need an available B-channel.
To enable ISDN Call Waiting
ISDN Call Waiting can only be enabled by your ISDN service provider. If you are unsure if your ISDN line has
this feature, check with your provider.
Using Call Waiting when alerted to a second incoming call
These commands apply to both DIVA LAN ISDN Modem Call Waiting and ISDN Call Waiting. To use the
following keypad commands, your ISDN line must also support Call Hold.
To ignore an incoming call
Do nothing. The two beeps will repeat once more, ten seconds later.
To reject an incoming call
1.
Press R.
2.
Wait for a dial-tone.
3.
Press 0.
4.
The incoming caller will receive a busy signal. Call Waiting will also be disabled for the duration of the
call.
To disconnect from the current call and accept the incoming call
1.
Press R.
2.
Wait for a dial-tone.
3.
Press 1.
To place the first call on hold and answer the incoming call
1.
Press R.
2.
Wait for a dial-tone.
3.
Press 3.
4.
Once the call is on hold, you can toggle back and forth between the two parties by pressing R, then 2. To
disconnect from the current call and reconnect to the held call, press R, then 1.
Vista de página 87
1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 190 191

Comentários a estes Manuais

Sem comentários