Eicon Networks C21 Guia de Instalação descarregar pdf (Página 61)

Remote Eiconcard Commands 61

Administration Commands

Administration commands allow workstation users to control dialing and SNA

resources on any gateway to which they are attached (with ECLAN USE). The

following commands can be issued:

ECDIALER

The ECDIALER command enables you to make and receive calls, display

status information, and to hang up calls.

ECSNA

The ECSNA command enables you to create, configure, activate, and

deactivate SNA Nodes and logical Units.

Note

Install these commands with caution. Since they allow direct control of

the gateway functions, inappropriate use of these commands may interfere with

the operation of the gateway. For example, the ECSNA command has options

that allow it to start, stop, and reconfigure Nodes. Any one of these options

could interrupt gateway operations for other users on the LAN.

The best way to make these commands accessible on the LAN is to install them

in a protected folder on the file server. This gives only authorized users easy

access to them from anywhere on the LAN.

NetView Commands

NetView commands enable you to use Eicon’s SNA network management

support (Netview Support must be configured on the gateway PC).

ECNETV

ECNETV is the SNA Network Management Support Console. It runs from a

Windows Command Prompt, or a DOS or OS/2 command line. It enables you

to build and send operator-generated alerts, display Response-Time monitor

(RTM) and RECFMS statistic data displays, and capture RTM and RECFMS

data to disk or printer. It emulates the TEXT mode feature of the IBM 3274/

3174 control unit.

ECRUNCMD

ECRUNCMD is a DOS or OS/2 application that is written specifically to

interface with NetView’s RUNCMD. it allows a host terminal to use NetView

or Net/Master to issue commands on the gateway or a workstation.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 214 215

Sem comentários

Eicon Networks C21 Guia de Instalação Página 61