Eicon Networks C21 Guia de Instalação descarregar pdf (Página 74)

ECDIALER: Using a Modem 74

ECDIALER: Using a Modem

Executable

ECDIALER.EXE

Purpose

Dials, hangs up, monitors, and configures the Eiconcard dialers. This

command can also be used to determine the state of the hardware link.

Preloaded

Executables

You must have already run ECCARD START for this executable to run

successfully.

Commands

Use the command appropriate to your operating system.

ECDIALER STORE [/Main n] [/ALternate n] [/NType t]

[/NPlan p] [/SAddr a] [/SType t]

[/Tns t] [/BCtype b]

[/Port n|portname] [/Outfile f]

ECDIALER DIAL [/NUmber n] [/NType t] [/NPlan p]

[/SAddr a] [/SType t] [/Tns t]

[/BCtype b] [/Port n|portname]

[/Outfile f]

ECDIALER EXEC /File script [/Port n|portname]

[/Outfile f]

ECDIALER ANSWER /Enable|/Disable [/Port n|portname]

[/Outfile f]

ECDIALER HANGUP [/Port n|portname] [/Outfile f]

ECDIALER STATUS [/Port n|portname] [/Outfile f]

ECDIALER LINE /ON|/OFF [/Port n|portname]

[/Outfile f]

Parameters

ANSWER

Use this option for all dialer types except Direct.

Enables or disables the dialer from answering

incoming calls.

For ISDN cards configured as a 2B terminal, where

both ports can accept the incoming call, the call will

always be answered by port 1.

DIAL

Use this option for Hayes AT, ISDN, and V.25bis

dialer types.

Dial the telephone number specified with the /NU

parameter. If no number is specified, dial the Main

(or Alternate number if there is one) that has been

STOREd. If the Retry parameter has been enabled

in the Eicon Configuration Tool, then dialing is

repeated until successful or the Retry counter has

expired.

EXEC

Supported by Hayes AT dialers only. Execute a script

for programming an external modem.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 214 215

Comentários a estes Manuais

Sem comentários

Eicon Networks C21 Guia de Instalação Página 74

Comentários a estes Manuais